- Jun 6, 2020
- 11,559
- 4,422
I am looking for the correct way to drive a
I need your help to understand why sending the following commands to the display serial port does not work as well as I expect
In the sense that the first command is executed correctly, while the last two do not
Obviously the text type controls t1, t2, t3 are present on the display page
t1.txt = "Out of range" ÿÿÿ
t2.txt = "10,345.67" ÿÿÿ
t3.txt = "44444" ÿÿÿ
Has any of you already used this type of display and can you tell me why the first command is executed while the other two are not?
برای دیدن لینک ها باید ثبت نام کنید
using B4J programI need your help to understand why sending the following commands to the display serial port does not work as well as I expect
In the sense that the first command is executed correctly, while the last two do not
Obviously the text type controls t1, t2, t3 are present on the display page
t1.txt = "Out of range" ÿÿÿ
t2.txt = "10,345.67" ÿÿÿ
t3.txt = "44444" ÿÿÿ
Has any of you already used this type of display and can you tell me why the first command is executed while the other two are not?
برای دیدن لینک ها باید ثبت نام کنید